91
ENGLISH
SETTING FURTHER CHANNELS
-----------------------------------------------------
Searching for digital chan-
nels from a satellite manually
on a transponder
If a certain channel cannot be found with
automatic search, you can search it manually
by manual search function. You must enter all
parameters of the channel correctly. You can
obtain the current transponder information from
teletext page, satellite TV magazines or internet.
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
V
«, »
Λ
«,
»
<
« or »
>
« and press »OK« to confirm.
3 Select the menu item »Source« with »
>
« or
»
<
« and press »
V
« to confirm.
– »Source« menu is active.
4 Select the line »Manual Channel Search«
with »
V
« or »
Λ
« and press »OK« to
confirm.
5 Select the option »Satellite (DVB-S/S2)«
with »
V
« or »
Λ
« and press »OK« to
confirm.
6 Select the required option for manually
adjusting with »
V
« or »
Λ
«:
Service Type
Press »
<
« or »
>
« to select whether you
want to search for only television channels
(DTV), only radio channels (Radio) or both
(Radio+TV).
Scan Type
Press »
<
« or »
>
« to select whether you
want to search for only free digital television
channels (Free), only scrambled digital
television channels (Scrambled) or both
(Free + Scrambled).
Transponder
Enter the transponder frequency with
»1...0« in five digits.
Symbol Rate
Enter the transponder symbol rate
with »1...0« in five digits.
Polarization
Set the polarisation for the transponder to
»Horizontal« or »Vertical« using »
<
« or »
>
«.
Network Search
Select the network search with »
<
« or »
>
«
as »On« or »Off«.
7 Press »
« (red) to start searching.
– The »Digital Searching« menu appears,
and the scan for TV channels begins.
– All channels found on the transponder are
shown. The new channels will be added
to the bottom of the channel table.
Note:
7
The search can be aborted with »EXIT«.
8 Press »EXIT« to end the setting.
To Next Page
Loading...
Need help?
General