Using the MX400
3. When naming is complete, press the Store button again. Turn the Page/Select
or Program/Load knob to select the new user program memory location to store
to.
4. Press the Store button again to complete the store procedure.
eDItInG a ProGraM
Once a program has been loaded, you may find you want to make adjustments to it for
your particular application. Editing of programs is done using the Page/Select and
three Edit Knobs (A, B, and C) to the right of the Main Display. Each effect can
be edited independently by selecting it with the Page/Select knob. As the effect is
selected, its name is highlighted in the Main Display and three parameters become
visible for the effect at the bottom of the Main Display. The Edit Knobs can then
modify these three top level parameters.
(Fig. A)
Note: Dual Stereo programs feature a slightly different program screen which dis-
plays both program names. When Edit Knobs A, B, and C are turned, the three
parameters of the selected effect will be displayed momentarily for editing purposes and
then the name of the second program will reappear. (Fig. B shows Tape Delay as the
selected effect in a Dual Stereo Configuration program).
(Fig. B)
Edit Knobs A, B, and C will modify the Tape Delay effect’s Tempo, Delay Time, and
Feedback parameters respectively. In addition, Surround and Stereo Configuration
program effects have several other parameters that can be modified from the Edit
Effect menus.
Editing From the Program Display
1. While on the program screen, turn the Page/Select knob to highlight the effect
you want to edit.
13
MX400
To Next Page
Loading...
Need help?
General
