Double-click a program name to open it in the editor. The program settings are reflect-
ed in the Parameter knobs and buttons in the Program Editor window.
The selected program is now loaded in your MX400. Any changes made in the MX-Edit
Program Editor window will also occur simultaneously on the MX400 hardware.
The MX-edIT
TM
LIbRARy
The MX-Edit Library contains the Factory and User programs that are currently loaded
in your MX400. When you first open MX-Edit, it communicates via USB (or MIDI) with
the MX400 hardware, and populates the Library with all the information about each of
the Factory and User programs stored in MX400’s physical memory.
To view programs in the Library window, click the MX400 tab in the upper left corner,
then double-click the Factory or User icon to expand the Library and see the Factory or
User program lists. The Factory list is always the same, as Factory programs cannot be
overwritten; the User program list represents the User programs currently saved in your
MX400 hardware.
Note that there may be two tabs below the tool bar (one for each processor in the
MX400, depending on the MX400's mode). Each tab has its own list of programs
(Factory and User), and its own Program Editor window. You can load and edit pro-
grams for each processor via these two tabs.
The Library can support multiple devices at the same time. Each device that is con-
nected to the Library is represented by a name and an icon next to the tool bar (just
below the menus). To view, load, and edit programs for a device, click its icon.
edITING A PRoGRAM
To open a program, choose one of the following:
• To open a Factory or User program from the MX-Edit Library, double click on
that program number in the Library window.
37
The MX-Edit
TM
Editor/Librarian - Windows
®
and Mac
®
MX400
To Next Page
Loading...
Need help?
General
