User Manual of Network Fisheye Camera
51
No. ranges from 1 to 65535.
WebSockets Port: The default server port number is 7682. It can be changed to
any port No. ranges from 1 to 65535.
Note:
WebSocket and WebSockets protocol are used for plug-in free live view.
3. Click Save to save the settings.
Note: A reboot is required for the settings to take effect.
6.1.5 Configure NAT (Network Address Translation) Settings
Purpose:
NAT interface allows you to configure the UPnP™ parameters.
Universal Plug and Play (UPnP™) is a networking architecture that provides
compatibility among networking equipment, software and other hardware devices.
The UPnP protocol allows devices to connect seamlessly and to simplify the
implementation of networks in the home and corporate environments.
With the function enabled, you don’t need to configure the port mapping for each port,
and the camera is connected to the Wide Area Network via the router.
Figure 6-6 UPnP Settings
Steps:
1. Enter the NAT settings interface. Configuration > Network > Basic Settings >
NAT.
2. Check the checkbox to enable the UPnP™ function.
To Next Page
Loading...
Need help?
General
