User Manual of Network Fisheye Camera
66
6.2.9 Configuring HTTP Listening
Purpose:
The camera can send alarm information to the destination IP or host name via HTTP
protocol. If the network is disconnected, the data can be uploaded to the destination IP
or host name after the network connection is normal.
Before you start:
The destination IP or host name should support the HTTP protocol to receive the
alarm information.
Steps:
1. Enter the HTTP Listening interface, Configuration > Network > Advanced
Settings > Listening.
Figure 6-17 HTTP Listening
2. Enter the desired destination IP or host name, URL and port.
3. You can click Test to test whether the entered IP address or host name are valid.
4. Or you can click Default to reset the destination IP or host name.
To Next Page
Loading...
Need help?
General
