EasyManuals Logo
Home>HIKVISION>Security Camera>DS-2DE2A204IW-DE3

HIKVISION DS-2DE2A204IW-DE3 User Manual

HIKVISION DS-2DE2A204IW-DE3
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
8.2.2 FTP/NAS/Memory Card Uploading
If you have enabled and congured the FTP/NAS/memory card uploading, the device sends the
alarm
informaon to the FTP server, network aached storage and memory card when an alarm is
triggered.
Refer to Set FTP to set the FTP server.
Refer to
Set NAS for NAS conguraon.
Refer to Set New or Unencrypted Memory Card for memory card storage conguraon.
8.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
informaon when an alarm event is detected.
For email
sengs, refer to Set Email .
Set Email
When the email is congured and Send Email is enabled as a linkage method, the device sends an
email
nocaon to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email funcon. Go to Conguraon → Network → Basic
Sengs → TCP/IP for DNS sengs.
Steps
1.
Go to email sengs page: Conguraon → Network → Advanced Sengs → Email .
2.
Set email parameters.
1) Input the sender's email
informaon, including the Sender's Address, SMTP Server, and
SMTP Port.
2)
Oponal: If your email server requires authencaon, check Authencaon and input your
user name and password to log in to the server.
3) Set the E-mail
Encrypon.
When you select SSL or TLS, and disable STARTTLS, emails are sent
aer encrypted by SSL or
TLS. The SMTP port should be set as 465.
When you select SSL or TLS and Enable STARTTLS, emails are sent aer encrypted by
STARTTLS, and the SMTP port should be set as 25.
Note
If you want to use STARTTLS, make sure that the protocol is supported by your email server.
If you check the Enable STARTTLS while the protocol is not supported by your email sever,
your email is sent with no encr ypon.
Network Speed Dome User Manual
61

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-2DE2A204IW-DE3 and is the answer not in the manual?

HIKVISION DS-2DE2A204IW-DE3 Specifications

General IconGeneral
Sensor typeCMOS
Progressive scanYes
Number of sensors1
Optical sensor size1/3 \
Maximum resolution1920 x 1080 pixels
Video compression formatsH.264, H.264+, H.265, H.265+
Analog signal format systemNTSC, PAL
Pan range0 - 330 °
Pan speed100 °/sec
White balanceATW, Auto, Manual
Tilt angle range0 - 90 °
Camera shutter speed1/1 - 1/30000 s
Minimum illumination0.005 lx
TypeIP security camera
Placement supportedIndoor & outdoor
Connectivity technologyWired
FocusMotorized/Manual
Digital zoom16 x
Optical zoom4 x
Focal length range- mm
Maximum aperture number2.7
Minimum aperture number1.6
Detection distance0.01 m
Audio input channels1 channels
Wi-Fi-
Number of users20 user(s)
Cabling technology10/100Base-T(X)
Networking standardsIEEE 802.1x
Compatible memory cardsMicroSD (TransFlash), MicroSDHC, SDXC
DC output voltage12
Power source typeDC
Power consumption (typical)12 W
Operating temperature (T-T)-20 - 60 °C
IK codeIK10
Form factorDome
Product colorBlack, White
Housing materialAcrylonitrile butadiene styrene (ABS), Aluminium, Polycarbonate (PC)
International Protection (IP) codeIP66
Weight and Dimensions IconWeight and Dimensions
Width130.7 mm
Height101.7 mm
Weight (with stand)530 g

Related product manuals