Trigger Recording
Record a video when an event occurs.
Note:
You have to set the recording schedule to realize this function. Refer to Section 5.1 Storage
Settings for settings the recording schedule.
Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.
Note:
To trigger an alarm output when an event occurs, refer to Section 6.1.4 Configuring Alarm Output
to set the alarm output parameters.
6.1.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the video tampering settings interface:
Configuration > Event > Basic Event > Video Tampering
Figure 6-7 Tampering Alarm
2. Check the Enable checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 4 in Section 6.1.1 Configuring Motion Detection.
4. Click tab to enter the arming schedule setting interface. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection. Refer to Step
5 in Section 6.1.1 Configuring Motion Detection.
To Next Page
Loading...
Need help?
General
