User Manual of DS-7100HWI/HVI-SL Series DVR
16
The Setup Wizard can walk you through some important settings of the device. By default, the Setup Wizard
starts once the device has loaded.
Operating the Setup Wizard:
Steps:
1. Select the system resolution from the drop-down menu. The default resolution is 1280×1024/60Hz.
Click Apply to save the resolution settings.
Figure 2.1 Start Wizard Interface
2. Check the checkbox to enable Setup Wizard when device starts. Click Next to continue the setup
wizard.
You can also click Cancel to exit the Setup Wizard, or use the Setup Wizard next time by leaving the
“Start wizard when device starts?” checkbox checked and exit.
Figure 2.2 Start Wizard Interface
3. Click Next button on the Wizard window to enter the Login window, as shown in Figure 2.3.
1) Enter the admin password. By default, the password is 12345.
2) To change the admin password, check the New Admin Password checkbox. Enter the new
password and confirm the password in the given fields.
To Next Page
Loading...
Need help?
General