Network Video Recorder User Manual
89
detected.
Steps
1. Go to System → Network → Advanced → Email.
2. Set the email parameters.
3. Click Apply.
4. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
5. Select Send Email alarm linkage action.
6.5.5 Configure Audio Alert
When an alarm is triggered, an audio file will be played as the linkage action. The audio file can be
customized. Refer to Audio Management for details.
Before You Start
Ensure the audio files are imported to the device.
Steps
Note
This linkage action is only available for certain events.
1. Check Audio Alert in Normal Linkage.
2. Click to select audio file.
3. Select an audio file.
4. Set arming schedule.
5. Click OK.
6. Click Apply.
6.5.6 Trigger Alarm Output
The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and any all other events.
Steps
1. Go to Linkage Action interface of the alarm detection (e.g., motion detection, face detection,
line crossing detection, intrusion detection, etc.).
2. In Trigger Alarm Outputs area, select the alarm output (s) to trigger.
3. Go to System → Event → Normal Event → Alarm Output.
4. Select an alarm output item from the list.
To Next Page
Loading...
Need help?
General
