Rail Network Video Recorder User Manual
46
7.1 Display Settings
Purpose:
You can set the system time, select the CVBS output standard, enable the password, configure the DST settings,
etc.
Steps:
1. Enter the Display Settings interface.
Main Menu > Other Settings > Display
The system language is set as English by default and is not editable.
Figure 7. 2 Display Settings
Optionally, you can do following steps to configure the following parameters according to your needs.
Set the CVBS Output Standard as NTSC or PAL according to the actual video input standard.
Click and to Set the System Time.
Select the VGA Resolution from the drop-down list.
The VGA resolution is only configurable when the Rail NVR is connected to a VGA monitor. And you can set it
as 1024*768/60Hz, 1280*720/60Hz, 1280*1024/60Hz, 1600*1200/60Hz, or 1920*1080/60Hz.
Check the checkbox of Enable Password to enable the password authentication before operations.
Click the Set button of DST Settings, and you can configure the DST (Daylight Saving Time) for the system.
Perform the following steps to configure the DST settings.
1) Check the checkbox of Enable DST.
2) Set the start time and end time for the DST period.
3) Select the DST bias from the drop-down list.
4) Click Apply to save the settings and click OK to exit.
To Next Page
Loading...
Need help?
General
