To Next Page

To Previous Page

Before You Start

Enable the UPnP™ funcon of your router if UPnP™ is required. When the device network working

mode is mul-address, the default device route should be on the same network segment as the

LAN IP address of the router.

Steps

Conguraon → Network → General → NAT .

Check Enable.

Select Mapping Type as Manual or Auto

Auto The port mapping items are read-only, and the external ports are set by the router

automacally. You can click Refresh to get the latest status of the port mapping.

Manual Select an external port type. Click to edit External Port. You can use the default

external port No., or change it according to actual requirements. External Port

indicates the port No. for port mapping in the router.

The value of the RTSP port No. should be 554 or between 1024 and 65535, while

the value of the other ports should be between 1 and 65535 and the value must be

dierent from each other. If mulple devices are congured for the UPnP™ sengs

under the same router, the value of the port No. for each device should be unique.

Set the virtual server of your router, including internal source port, external source port, etc. The

virtual server parameters shall be corresponding with your device port.

6.2.4 Ports (More

Sengs)

Set dierent port types to enable relevant funcons as your desire.

Go to Conguraon → Network → General → More Sengs .

Alarm Host IP/Port

The device will send the alarm event or excepon message to the alarm host when an alarm is

triggered. The remote alarm host must have the client management system (CMS)

soware

installed.

Alarm Host IP refers to the IP address of the remote PC on which the CMS

soware (e.g.,

iVMS-4200) is installed, and the Alarm Host Port (7200 by default) must be the same as the

alarm monitoring port

congured in the soware.

Server Port

For remote client soware access. Ranges from 2000 to 65535. The default value is 8000.

HTTP Port

For remote web browser access. The default value is 80.

Mulcast IP

Mulcast can be congured to enable live view for cameras that exceed the maximum number

allowed through network. A mulcast IP address covers Class-D IP ranging from 224.0.0.0 to

Network Video Recorder User Manual

HIKVISION HWN-4108MH-8P User Manual

Questions and Answers: