Basic Settings
RM Web L2B
Release
5.3
05/2012
1.6
Loading/Saving the Configuration
35
If you change the current configuration (for example, by switching a port off),
the Web-based interface changes the “load/save” symbol in the navigation
tree from a disk symbol to a yellow triangle. After saving the configuration,
the Web-based interface displays the “load/save” symbol as a disk again.
1.6.3 URL
The URL identifies the path to the tftp server on which the configuration file
is to be stored. The URL is in the format: tftp://IP address of the tftp server/
path name/file name (e.g. tftp://192.168.1.100/device/
config.dat).
Note: The configuration file includes all configuration data, including the
passwords for accessing the device. Therefore, pay attention to the access
rights on the tftp server.
1.6.4 Deleting a configuration
In the "Delete" frame, you have the option to
Reset the current configuration to the state on delivery. The configuration
saved on the device is retained.
Reset the device to the state on delivery. In this case, the device deletes
its configuration in the volatile memory as well as in the non-volatile
memory. This includes the IP address. The device will be reachable again
over the network after it has obtained a new IP address, e.g., via DHCP
or the V.24 interface.
To Next Page
Loading...
Need help?
General
