Basic Settings
38
1.7
Restart
RM Web L2B
Release
5.3
05/2012
1.7 Restart
This dialog provides you with the following functions:
initiate a cold start of the device. The device reloads the software from the
non-volatile memory, restarts, and performs a self-test.
Reload the website in your browser to reaccess the device after
restarting.
initiate a warm start of the device. In this case the device checks the
software in the volatile memory and restarts. If a warm start is not
possible, the device automatically performs a cold start.
reset the entries with the status “learned” in the filter table (MAC address
table).
reset the ARP table.
The device maintains an ARP table internally.
If, for example, you assign a new IP address to a computer and
subsequently cannot set up a connection to the device, you then reset the
ARP table.
reset the port counters.
delete the log file.
Note: During the restart, the device temporarily does not transfer any data,
and it cannot be accessed via the Web-based interface or other management
systems such as Industrial HiVision.
To Next Page
Loading...
Need help?
General
