1. Installation construction
DO NOT install the indoor unit, outdoor unit, controller and cable at such places as;
1. Where there is oil vapor and the oil is dispersed
2. Where the hot springs are near (in a sulfuric environment)
3. Where generation, flowing, staying or leaking of flammable gas is detected
4. Where the sea is near (in the salty environment)
5. An acid or alkaline environment
DO NOT install the indoor unit, outdoor unit, controller and cable within approximately 3 meters from strong
electromagnetic wave radiators such as medical equipment. In case that the controller is installed in a place
where there is electromagnetic wave direct-radiation, shield the controller and cables by covering with the
steel box and running the cable through the metal conduit tube.
In case that there is electric noise at the power source for the indoor unit, provide a noise filter.
1. SAFETY SUMMARY
DANGER
DO NOT pour water into the remote control switch (hereafter called “controller”). This product is equipped
with electrical parts. If poured, it will cause a serious electrical shock.
WARNING
DO NOT perform installation work and electrical wiring connection by yourself. Contact your distributor or
dealer of Hisense and ask them for installation work and electrical wiring by service person.
CAUTION
The box
□
is for checking work .Check the box after checkig.
Installation & Maintenance Manual
Wired Remote Control Switch (Model: )
IMPORTANT:
READ AND UNDERSTAND THIS MANUAL BEFORE USING THIS WIRED REMOTE CONTROL SWITCH.
KEEP THIS MANUAL FOR FUTURE REFERENCE.
IMPORTANT NOTICE:
No part of this manual may be reproduced without written permission.
Signal words (DANGER, WARNING, and CAUTION) are used to identify levels of hazard seriousness. Definitions of
identifying hazard levels are provided below with their respective signal words.
DANGER
WARNING
CAUTION
: Immediate hazards which WILL result in severe personal injury or death.
: Hazards or unsafe practices which COULD result in severe personal injury or death.
: Hazards or unsafe practices which COULD result in minor personal injury or product or property
damage
NOTE: Useful information for operation and/or maintenance.
HYXE‐
F01H
Groove for Attaching Controller
Groove Part
2. Installation Work
[2.1 Selection of Installation Place]
□
1)
●
where children can touch
●
where the air from the air conditioner is directly discharged
Select a suitable place for handling and determine the installation place of the controller with the customer's acceptance. Do not install the controller at such places as;
[2.2
Before Installation]
□
This packing contains the following parts.
[2.3 Installation Procedures]
□
Insert the edge of the slotted screwdriver into the groove at the bottom
of the holding bracket,push and turn the slotted screwdriver and then
remove the controller from the holding bracket.
1)
Figure Seen from Bottom Side
Approx. 6mm
Slotted Screw
Driver
Groove Part for Removing Contronller
□
2)
Attach the controller to the holding bracket and connect the cable as follows.
A. In Case of Exposing Remote Control Cable
Fix the holding bracket
onto the wall with screws
(accessory)
Cable
Attach the stopper to the
cable at the inside of the
draw-out hole.
Lead the cable with its
sheath peeled through
the groove.
Peel the insulation at
the end of the cable and
clamp the M3 solderless
terminals (field-supplied).
Remote control Switch……1
Assembling screw(M4*16mm)……2
Installation Spot check specification……1
1)
HYXE-F01H
To Next Page
Loading...
Need help?
General
