Do not turn ON the power source, unless the preparation for test running is completed.
G Read this manual carefully before installation work for correct performance.
G Read this manual together with the “Installation & Maintenance Manual” for the indoor unit.
GJ is the blank box for checking. Mark the blank box J for the item after checking.
Model:
Operation & Installation Manual for
Wireless Remote Control Switch (Unidirectional Type)
1. Before Installation and Operation
J Set the batteries (AAA/1.5V2) for the controller as follows.
(1) Remove the battery cover by sliding toward the arrow direction by
pushing the part of the cover as shown in the figure below.
(2) Set the batteries.
2. Setting Batteries
J This packing contains the following parts.
Check the contents and the number of the parts.
Name
Wireless Remote Control Switch
(Controller)
Holding Br
acket
Screw
Q'ty Remark
1
1
For Operation Control
For Controller
For Fixing "Holding Bracket" onto Wall
Slide toward the arrow
direction by pushing.
2
L
(Insert the batteries according to the marks of + and - on the case.)
HYE-L01
To Next Page
Loading...
Need help?
General
