Push-button Function
1 Heating system On/off switch - red LED shows function.
2 Floor heating On/off switch - red LED shows function.
(not standard equipment)
3 Light in outer tent On/off switch for light in outer tent.
4 Wall lamps On/off switch for lamps.
Holding the push-button activates the dimmer function. Light increases
and decreases.
5 Kitchen lamp On/off switch for lamp.
6 Diffused reecting lights On/off switch for lamps.
7 Ceiling lamp On/off switch for lamp.
Holding the push-button activates the dimmer function. Light increases
and decreases.
8 Indirect lighting On/off switch for indirect lighting (top).
9 Indirect lighting 2 On/off switch for indirect lighting (bottom).
10 Water tank Level indicator for water tank.
11 Main switch 1 short press of the push-button
Turns off all consumers connected to this system; saves the selection
status(on/offordimmed).Doesnotaffectheatingsystemandoor
heating.
Press the push-button again to activate the lights to the previously
saved status.
If you hold the push-button for 5 seconds when turning it off, all of the
consumers connected to this system, including the heating system and
theoorheating,areturnedoff.
(The memory is reset.)
General information The main switch is only for the consumers connected to this system!
Lamps and other consumers, e.g. the refrigerator, water pump, etc., are
not controlled and/or switched using this switch.
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
Need help?
General
