12. Maintenance and upkeep
150
12.4 Changing bulbs in the rear lights
Dierent rear lights are used in the Premium models. Unfortunately,
it is not possible to replace these lights easily. In this case, please
speak to your dealer, who will be pleased to assist you in changing
these light bulbs.
Some of the rear lights in the Premium models are
tted with LED lights, whereby each individual light
has a standardised alignment. Therefore, due to the
authorisation required, individual LED lights may not
be changed. Should they be defect, the entire rear light
must be replaced.
Changing the licence plate illumination
• To change the registration plate light, rst unscrew these
screws
j
.
• Remove the two wires
k
and attach them to the new light
(They can re connected to any terminal).
• When putting in the new light, take care to ensure that the clo-
sed side
l
of the light points towards the plastic on the rear
bumper
k
. Otherwise there is a danger that the plastic on
the rear bumper will melt when heat is generated.
• Firmly tighten the screws
j
to fasten the light securely.
1
2
3
4
Registration plate light
Removing the cable
Lamp
Disconnect the power supply before changing the
lamps!
Lamps can be hot!
Ensure that no liquids (e.g. rain) ow into the covers.
To Next Page
Loading...
Need help?
General
