Honda BF15D User Manual

7. RECOIL STARTER BF15DmBF20D
I 1. NEUTRAL START CABLE
2. RECOIL STARTER
3. STARTER CASE B
1. NEUTRAL START CABLE
a. REMOVAL
1) Remove the engine cover.
2) Shift the gear into the neutral position.
3) Disconnect the upper cable end from the stopper arm.
4) Disconnect the lower cable end from the shift shaft.
5) Loosen the lock nut and adjusting nut, then remove the
neutral start cable.
, b. INSTALLATION
1) Make sure the gear in the neutral position.
2) Connect the neutral starter cable lower end to the shift
shaft.
3) Route the cable properly (P. 2-28) and set the cable outer
end
to the recoil starter case, then connect the cable
upper end
to the stopper arm.
4) Adjust the neutral start cable as follows.
c. ADJUSTMENT
1) Remove the engine cover and shift the gear into the neu-
tral position.
2) Loosen the lock nut and turn the adjust nut until the
groove of the stopper arm aligns with the index mark on
the recoil starter case.
3) Tighten the lock nut securely.
4) After adjustment check for proper operation of the neutral
5) Install the engine cover.
start mechanism by operating the recoil starter.
[l] NEUTRAL START CABLE
PER
[6] CAB
..
HOLDER
SHAFT
[5] STOPPER ARM
7-1

Honda BF15D Specifications

General

Brand	Honda
Model	BF15D
Category	Outboard Motor
Language	English