8.
E
NG
I
N
E
RE
MOVAUI NSTALLATIO N
1
1.
ENGINE REMOVAL
2. ENGINE INSTALLATION
1.
ENGINE
REMOVAL
1) Remove the following:
-
engine cover
(P.
5-1).
-
left engine under cover
(P.
5-2).
-
right engine under cover
(P.
5-3).
-
recoil starter
(P.
7-1) and neutral start cable
(P.
7-9).
-
remote control cables
(P.
14-2).
-
remote control
box
wire harness
(P.
14-3).
2) Drain the engine oil
to
a suitable container
(P.
3-3).
3) Remove the two
6
x
22 mm flange bolts and silencer
cover.
4) Loosen the carburetor drain screw and drain the carbure-
tor
to
a suitable container.
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when han-
dling fuel.
Keep heat, sparks, and flame away.
Handle fuel only outdoors.
Wipe up spills immediately.
5)
Disconnect the fuel tube
B
from the fuel filter.
6)
Loosen the pivot bolt fully. Remove the cotter pin and 7
mm
washer and disconnect the shift linkage from the shift
shaft (Remote control type only).
1
[l] FUEL TUBE B
[l] COTTER PIN
[2]
7
mm
WASHER
[4]
PIVOT
BOLT
[3] SHIFT LINK
ROD
To Next Page
Loading...
Need help?
General
