4.
CRANKSHAFTKYLINDER BLOCK
a.
DISASSEMBLY
1) Remove the engine (Section8) and remove the following:
-
flywheel and timing belt drive pulley
(P.
9-2 and 10).
-
silencer and carburetor
(P.
6-2)
-
fuel pump and fuel filter
(P.
6-17).
-
cylinder head
(P.
10-2).
2) Turn the crankshaft until the piston is at top dead center
3)
Remove the eight
6
x
28 mm flange
bolts.
Loosen the bolts in a crisscross pattern in 2
-
3
steps.
4) Insert a screwdriver or equivalent tool into the concave in
the position shown, and lift the crankcase cover slightly.
Be careful not
to
damage the mating surface when
removing the crankcase cover.
5)
Remove the crankcase cover and 8
x
14 mm dowel pins.
CRANKCASE
6)
Remove the four 6
x
22 mm flange
bolts
and crankcase
S,DE
COVER
GASKET
side cover and side cover gasket.
11-16
To Next Page
Loading...
Need help?
General
