Additional Gear Case Oil
1)
Remove the oil check bolt.
2)
Remove the oil drain bolt, and install a commercially
available gear oil pump or gear oil bottle in the oil drain
bolt hole. Add gear case oil until it flows out of the oil
check bolt hole.
Recommended
gear case
oil
SAE
#90
Hypoid gear oil or
equivalent
Oil Change
1)
Place the outboard motor vertical.
2)
Remove the oil check bolt, oil drain bolt, and drain the
gear case oil into a suitable container.
Check for water in the drained gear case oil.
If there is water in the gear case oil, check the gasket and
water seal for damage and check torque at each tighten-
ing point
of
the gear case.
3)
Install a commercially available gear oil pump or gear oil
bottle in the oil drain bolt hole.
FcLe oil capacity
~ 285
cc
(17.4
cu. in)
~ ~~~~ ~
-
4)
When the oil flows out of the oil level check hole, install
the O-ring and oil check bolt quickly.
Before installing the oil check and drain bolts, make sure
that the O-rings are in good condition, replace with new
one if necessary.
5)
Then install the O-ring and oil drain bolt.
6)
Tighten the oil drain bolt and oil check bolt
to
the speci-
fied torque.
TORQUE:
3.5
N*m
(0.35
kgf*m,
2.5
Ibfoft)
5.
SPARK
PLUG
Inspection/Cleaning
If the engine has been running, the engine will be very hot.
Allow it
to
cool before proceeding.
1)
Remove the engine cover.
2)
Remove the stopper ring and then remove the washer,
pin and cover latch.
[l] OIL
CHECK
BOLT
121
OIL
DRAIN
BOLT
[3]
O-RING
/
[3]
O-RING
[2] OIL
DRAIN
BOLT
To Next Page
Loading...
Need help?
General
