Honda CRF450R 2007 Service Manual

FRONT WHEEL/SUSPENSION/STEERING
SERVICE INFORMATION
GENERAL
• Keep grease off the brake pads and disc.
• A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a con tam inated disc
with a high quality brake degreasing agent.
• When servicing the front wheel, fork or steering stem, support the moto rcycle using a work stand or equivalent under
the engine.
• After front wheel installation, check the brake operation by applying the brake lever.
• Refer to the brake system information (page 16-3),
• When using the lock nut wre nch, use a 20-inch long deflecting beam type torque wrench. The lock nut wrench increases
the torque wrench's leverage, so the torque wrench reading wi ll be less than the torque actually applied to the fork
damper. The specification given on this page is actual torque applied to the fork damper , not the reading on the torque
wrench when used wit h the lock nut wrenc h. The procedure later in the text gives the actual and indicated torque.
SPECIFICATIONS
Unit: mm (in
EUMr
I
9B kPa
I
Axl'
,unout
, ~
Wheel ,im ,unout
-
2:0-
- 2.0
Wheel
,
I
See
*"
Fo,k
Sp,;ng " .
. I
i
-
lImk orr
Pw Honda HP Fo ,k orr 5W 0'
, I
orr l
,v,l 42 - 4711.65 - 1.B51
-
Fluid
fil ll0U ~
'05 '-' 071
1~~, '071
-
o,k 192 om' 16 .5 US 0' , 6.B Imp 0,1
-
~
,
~
Ii I I
I
'dl ok,_ ,fu
-
Aft"
,full In
-
",:C,'
""
, orr
Pw Honda HP Fo,k orr 5W 0'
,. "0_
I
F'ee piston deplh 16B ' FI
213-
, I fo",.
9 clicks out from full in
-
14-4
•

Honda CRF450R 2007 Specifications

General

Brand	Honda
Model	CRF450R 2007
Category	Motorcycle
Language	English