Honda CRF450X 2005 User Manual

BRAKE FLUID
I NOTICE
Spilled fluid can damage painted, plastic or rubber
parts. Place a rag over these parts whenever the
system is serviced.
• Do not mix different types of fluid, as they are
not compatible with each other.
• Do not allow foreign material to enter the system
when filling the reservoir.
FLUID LEVEL INSPECTION
When the fluid level is low, check the brake pads for
wear (page 4-30), A low flu id level may be due to
wear of the brake pads. If the brake pads are worn,
the caliper piston is push ed out, and th is accounts
for a low reservoir level.
If the brake pads are not worn and the fluid level is
low, check the entire system fo r leaks (page 4-29).
FRONT BRAKE:
Turn th e handlebar so that the reservoir is level and
check the front brake fluid level.
If the level is near the lower level line, check the
brake pad wear (page 4-30),
REAR BRAKE:
Support the motorcycle in an upright position on a r--
level surface,
If the level is near the lower level line, check the
brake pad
wear (page 4-30),
FLUID FILLING
• Inspect the brake' hose and fittings for deteriora-
tion, cracks or signs of leakage, Tighten any
loose
fittings,
• Replace the ho se and fittings as required,
FRONT:
Remove the screws, cover and diaphragm,
Fill the reservo ir with DOT 4 brake fluid to the upper
level line.
Install the diaphragm and cover.
Tighten the screws to the specified torque.
TORQUE: 1.0 N,m (0.1 kgf ·m, 0.7 Ibf.ft)
Check the entire system for leaks.
MAINTENANCE
UPPER LEVEL LINE
4-29

Honda CRF450X 2005 Specifications

General

Brand	Honda
Model	CRF450X 2005
Category	Motorcycle
Language	English