Honda CRF450X 2008 Service Manual

CRANKCASE/CRANKSHAFT /TRANSMISSION/BALANCER
13-20
Clean and apply locking agent to the countershaft
bearing set plate screws.
Install the screws with the set plates and tighten the
screws to the specified torque.
TOROUE: 10 N'm (1.0 kgf ·m, 7 Ibf · tt)
Apply grease to new coun tershaft and balancer
shaft oil seal lips.
Install
a new balancer shaft oil seal to the crankcase
until it is flush wit h the crankcase surface.
Install a new countersha ft oil seal to the specified
depth below the crankcase surface as s hown .
BALANCER SHAFT OIL SEAL:
0 - 1.0 mm (0 - 0.04 in)
COUNTERS HAFT O IL SEA L:
RIGHT CRANKCASE
Remove the socket bolts and set plates.
Remove the countershaft bearing, mainshaft bear·
ing and shift drum bearing.
Remove the bolts and set plates.
Remove the balancer shaft bearing.
..
lit ..... OIL SEALS
on ' T< '<OT PLATES

Honda CRF450X 2008 Specifications

General

Brand	Honda
Model	CRF450X 2008
Category	Motorcycle
Language	English