11-20
HANDLEBAR/ CABLES/CONTROLS HRN216
REASSEMBLY
1. Install the Roto-Stop cable cylinder end in the Roto-Stop
arm assembly.
2. Install the Roto-Stop cable ferrule in the Roto-Stop left
case.
3. Install the Roto-Stop arm assembly in the Roto-Stop left
case. Make sure the Roto-Stop arm assembly is rotated
to the back of the Roto-Stop left case as shown.
4. Position the yellow push knob in the Roto-Stop right
case. Install the lever return spring between the push
knob and the Roto-Stop right case and hold the push the
knob in place.
ROTO-STOP
CABLE
CYLINDER END
ROTO-STOP ARM
ASSEMBLY
ROTO-STOP CABLE
ROTO-STOP ARM
ASSEMBLY
ROTO-STOP
FERRULE
ROTO-STOP
LEFT CASE
ROTO-STOP
RIGHT CASE
LEVER
RETURN
SPRING
PUSH KNOB
Hold in place.
To Next Page
Loading...
Need help?
General
