To Next Page

To Previous Page

6-2

MUFFLER HRN216

1. REMOVAL/INSTALLATION

 CAUTION

The engine and muffler become very hot during operation, and

they remain hot for a while after operation.

A hot engine or muffler can burn you.

Be sure that the engine is cold before muffler removal/installation.

12 N•m (9 ft-lb)

6 x 23 mm BOLT (3)

MUFFLER

MUFFLER GASKET

[optional part]

MUFFLER PROTECTOR

6 x 79 mm BOLT (CT bolt*) (2)

4 x 6 mm SCREW

[optional part]

· Use a plastic hammer to loosen carbon deposits

from the muffler, and then remove carbon deposits

from muffler.

· If the seal flange is dented or damaged, replace the

muffler.

· Check the cylinder barrel exhaust port for damage.

· Do not tap on the muffler seal flange and do not

damage this part.

MUFFLER SEAL

FLANGE

EXHAUST PORT

SPARK ARRESTER [optional part]

INSTALLATION:

Install after removing the carbon from the

screen with a wire brush.

Inspect for tears or damage.

* CT indicates a self-tapping bolt

Honda HRN216VYAA User Manual

Other manuals for Honda HRN216VYAA