Honeywell BENDIX/KING RDR 2000 User Manual

BENDIX/KING RDR 2000
Rev 7, July/2002 00643I05.TDC Page 2-33
3. Set the tilt table to 10
°
pitch up. The value should be 10.0U ± 1.0
°
. If the value is
out of range, repeat Steps 1 and 2 of this section.
4. Set the tilt table to 10
°
pitch down. The value should be 10.0D ± 1.0
°
. If the value
is out of range, repeat Steps 1 and 2 of this section.
5. Set the tilt table to 0
°
pitch. The value should be 0.0 ± 1.0
°
.
6. Proceed to Step R.
R. ARINC 429 ROLL OFFSET
1. Set the tilt table for 0
°
pitch and roll. Press the GND MAP button to display the 429
ROLL OFFSET page (see figure 2-19).
2. Press the WxA to display brackets around the ROLL value. Adjust the TILT knob
for a ROLL value of 0.0 ± 1.0
°
. Press the WxA button to deselect the brackets.
3. Set the tilt table to 10
°
roll right. The value should be 10.0R ± 1.0
°
. If the value is
out of range, repeat Steps 1 and 2 of this section.
4. Set the tilt table to 10
°
roll left. The value should be 10.0L ± 1.0
°
. If the value is out
of range, repeat Steps 1 and 2 of this section.
5. Set the tilt table to 0
°
roll. The value should be 0.0 ± 1.0
°
.
6. Proceed to Step S.
S. Save Configuration
1. Press the Wx button until the MAINT FUNCTIONS menu is displayed.
2. Press the GND MAP button to move the select pointer to SAVE SETUP DATA.
See figure 2-20A.
3. Press the WxA button to display the save option page. See figure 2-20B. Press
the WxA button again to initiate the save process.
If the save process is successful, COPY PASS will be displayed for five seconds
before the display returns to the ART 2000 MAINTENANCE page. See figure 2-
20B.
If the save process is unsuccessful, COPY FAIL will be displayed. Try again.

Honeywell BENDIX/KING RDR 2000 Specifications

General

Brand	Honeywell
Model	BENDIX/KING RDR 2000
Category	Radar
Language	English