12
Set with faults
Although not normally permitted, you can set with a fault if your system is
programmed for this and you have the correct user access level.
If there are faults present when you try to set via the keypad, the fault override
message is displayed:
To set with one or more faults:
1. Scroll through the faults. If you are able to override a fault the Continue Set
option is displayed as shown in the example below.
2. Press
ent
to override the fault for one set period only and allow the system to
set. If there is more than one fault, repeat this process for each fault.
Unset the system
To unset the system:
1. Enter the protected area by the agreed route.
A
timed entry period begins and a
pulsed tone sounds.
2. Do one of the following:
Keypad: Enter your user code, then press
ent
†
.
Keyfob: Press (the second button down).
Prox tag or card: Hold the tag or card in front of the prox symbol/MAX
4
reader.
† In the UK, on DD243 compliant systems, a user code cannot be used to unset the
system and a prox card or tag must be used instead.
A
user code can only be used
after an alarm condition has occurred.
ALERT-AC FAIL
ent=CONTINUE SET
To Next Page
Loading...
Need help?
General
