21
Output Test (32 ent)
Use this option to test the external bell and strobe.
To test a bell or strobe:
1. Select either bell or strobe, and then press
ent
. The device state (on or off) is
displayed.
2. Press
ent
to toggle the status on or off to test the device.
3. Press
esc
to end the test.
Time/date (41 ent)
Use this option to set the system time and date. There are two sub-options;
A=TIME and B=DATE.
Enter time in 24 hour notation (hh:mm), and the date in 6-digit notation
(dd/mm/yy).
Codes (42 ent)
The system can have up to 100 users, with user codes assigned as follows:
001 to 097 assigned to any user
098 reserved for Manager
099 reserved for Engineer
100 reserved for remote access
You can give each user a PIN code, a wireless keyfob and/or a prox tag. Once
assigned, users can modify their own PIN codes. You can also assign an access
type that controls what the user can and can’t do.
Press 42
ent
1
ent
to view users. The first user details are displayed and a typical
example is shown below:
Use
A
and
B
to scroll to other users.
Press
ent
to show the options for that user, starting with Modify PIN. Use
A
and
B
to scroll between the options.
001 USER R □ m
To Next Page
Loading...
Need help?
General
