20
Access Doors (25 ent)
Use this option to display event log information about access control events. The
events can also be filtered by:
Individual DCM or MAX readers
Individual Users
Walk Test (31 ent)
Use this option to view tested and untested zones and to activate a walk test. We
recommend you perform a walk test every month.
To test all zones:
Press
2 ent 2 ent 1 ent
.
To test selected zones:
1. Press
2 ent 2 ent 2 ent
. The first zone is displayed with the zone number and
description on the top row. The test status is displayed on the bottom row.
2. Press
#
to select the displayed zone for test. The message in the lower corner
displays as appropriate.
3. Navigate to, and select other zones to test.
4. When all required zones have been selected for test, press
ent
to start the test,
or
esc
to abort.
Once a test has started, any activation of a detector on test causes the internal
sounders to beep twice. The zone number and description are displayed on the
keypad. When more than one zone is activated at the same time, use the scroll keys
to view all the active zones.
Note: Ensure that wireless detectors on test are left undisturbed for three minutes
before activating the walk test. This is because wireless movement detectors
enter a sleep mode after being activated in order to save battery life during
repeated activations.
To end the walk test:
Press the
esc
key.
All walk tested zones are recorded in the event log.
To Next Page
Loading...
Need help?
General
