Honeywell Lynx Plus Series Installation And Setup Guide

Lynx Plus Series Installation and Setup Guide
- 6 -
Mounting the Control
Wall Mounting
1. Release the front assembly from the
back case by depressing the two
locking tabs at the top of the unit
with the blade of a medium size
screwdriver.
2. Separate the front and back case
assemblies by rotating the front case
so that it is perpendicular to the
back case and unsnapping
(releasing) the two hooks from the
back case.
3. Feed the field wiring through the
appropriate openings in the back
case. Use tie-wraps to secure the
wiring to the built-in wire loops as
needed.
4. Mount the back case to a sturdy
wall.
5. Attach the front and back cases by
connecting the hooks on the front
case to the attachments on the rear
case. Once attached, the hooks will
support the front case and allow you
to make the wiring connections.
6. After all wiring connections have
been made, snap the front case and
back case closed and ensure that
the control is secured by the locking
tabs.
BACK
CASE
FRONT
CASE
1000-300-009-V1
ROTATE
FRONT CASE
UPWARD
TO RELEASE
HOOKS
MOUNTING
HOOKS
LOCKING TABS
Desktop Mounting
For desktop mounting, the optional
mounting base (model LYNXPLUS-
DM, purchased separately) must be
used.
1. Slide the control panel onto the
mounting base locking tabs.
2. Bring all wiring through the bottom
of the mounting base, using one of
the wire entry locations, before
making connections to the control
panel.
3. Use tie-wraps to secure the wiring to
the built-in wire loops as needed.
4. Use the supplied screws to secure
the control panel to the mounting
base.
BYPASS
NO DELAY
RECORD
TEST
FUNCTION
STATUS
VOLUME
PLAY
CODE
LIGHTS ON
LIGHTS OFF
CHIME
ESCAPE
ADD
DELETE
SELECT
OFF
STAY
1
32
AWAY
AUX
4
6
5
ARMED
READY
7
9
8
0
1000-300-016-V0

Honeywell Lynx Plus Series Specifications

General

Brand	Honeywell
Model	Lynx Plus Series
Category	Security System
Language	English