P9
Battery
EDA51-X uses 3.8V rechargeable lithium ion battery as its main power supply. The battery capacity is 15.2
watt/hour. Battery life is influenced by many factors, such as: screen brightness, the length of time before the
screen automatically go to sleep, input configurations, extreme temperature and using behaviors, etc.
Honeywell suggests you to keep the battery charged to avoid data loss. Change battery only after switching off the
device as per normal. Switch on the device after completing change of battery.
If you need to buy a replaceable battery, please contact regional resellers.
We would recommend using only Honeywell’s lithium battery; any damage caused by use of non-Honeywell
battery is not covered by warranty.
Warning:
Improper use of the battery of this device can cause a fire or chemical burns. Please don't disassemble
the battery or heat it to 100 °C (212 °F) and above, or incinerate the battery. Make sure waste batteries
are properly disposed. Keep out of reach of the children.
Do not store the battery without using for a long time. If store the battery for over 3 months, please
make sure check the remaining battery power capacity over 30% every 3 months.
Charging
Before using EDA51-X, you need to make sure the battery (model number: BAT-EDA50) is fully charged. You
can charge the battery before or after installing it to EDA51-X. It will take about 5 hours for the battery to be fully
charged using original charger, quad bay charger, single cradle charger.
We would recommend using Honeywell’s original charger; any damage caused by use of non-Honeywell charger
is not covered by warranty
To Next Page
Loading...
Need help?
General