Self-Test Errors
The following errors indicate failures that may occur during a self-test.
Refer to the HP 34970A Service Guide for more information.
601 Self-test: front panel not responding
602 Self-test: RAM read/write
603 Self-test: A/D sync stuck
604 Self-test: A/D slope convergence
605 Self-test/Cal: not able to calibrate rundown gain
606 Self-test/Cal: rundown gain out of range
607 Self-test: rundown too noisy
608 Self-test: serial configuration readback
609 Self-test: DC gain x1
610 Self-test: DC gain x10
611 Self-test: DC gain x100
612 Self-test: Ohms 500 nA source
613 Self-test: Ohms 5 uA source
614 Self-test: DC 300V zero
615 Self-test: Ohms 10 uA source
616 Self-test: DC current sense
617 Self-test: Ohms 100 uA source
618 Self-test: DC high voltage attenuator
619 Self-test: Ohms 1 mA source
620 Self-test: AC rms zero
621 Self-test: AC rms full scale
622 Self-test: frequency counter
623 Self-test: not able to calibrate precharge
624 Self-test: not able to sense line frequency
625 Self-test: I/O processor not responding
626 Self-test: I/O processor self-test
Chapter 6 Error Messages
Self-Test Errors
314
To Next Page
Loading...
Need help?
General