HP 5130 EI Switch Series User Manual

12
Figure 13 Connecting the grounding cable to the grounding hole of the switch
(1) Chassis rear panel
(2) Grounding sign
(3) Grounding hole
(4) Ring terminal
(5) Grounding cable
(6) Grounding screw
2. Connect the other end of the grounding cable to the grounding strip.
a. Cut the grounding cable to a length according to the distance between the switch and the
grounding strip.
b. Peel 20 mm (0.79 in) of insulation sheath by using a wire stripper.
c. Use the needle-nose pliers to bend the bare wire.
d. Hook the grounding cable to the post on the grounding strip, and use the hex nut to secure the
cable to the post.
Figure 14 Connecting the grounding cable to a grounding strip
(1) Grounding post
(2) Grounding strip
(3) Grounding cable
(4) Hex nut
1
2 3
4
5
6
1
2
3
4

HP 5130 EI Switch Series Specifications

General

Brand	HP
Model	5130 EI Switch Series
Category	Switch
Language	English