HP 5130 EI Switch Series User Manual

4
•
Electromagnetic wave radiation.
•
Common impedance (including the grounding system) coupling.
To prevent EMI, use the following guidelines:
•
If AC power is used, use a single-phase three-wire power receptacle with protective earth (PE) to
filter interference from the power grid.
•
Keep the switch far away from radio transmitting stations, radar stations, and high-frequency
devices to make sure the EMI levels do not exceed the compliant range.
•
Use electromagnetic shielding when necessary. For example, use shielded interface cables.
•
To prevent signal ports from getting damaged by over-voltage or over-current caused by lightning
strikes, only route interface cables indoors.
Laser safety
WARNING
!
Do not stare into any fiber port when the switch has power. The laser light emitted from the optical fiber
might hurt your eyes.
The HP 513 0 E I switches are Class 1 laser devices.
Installation tools
•
Flat-blade screwdriver
•
Phillips screwdriver
•
ESD wrist strap
All these installation tools are user supplied.
Installation accessories
Table 3 Installation accessories
Product
code
Description Quantity Applicable models
5066-0850
1 U four-hole mounting
bracket kit (including one
pair of mounting brackets
and eight M4 countersunk
screws)
1 kit
• H P 513 0 -24G-PoE+-4SFP+ (370W) EI
• H P 513 0 -48G-4SFP+ EI
• H P 513 0 -48G-PoE+-4SFP+ (370W) EI
• H P 513 0 -24G-SFP-4SFP+ EI
• H P 513 0 -48G-2SFP+-2XGT EI
• H P 513 0 -24G-PoE+-2SFP+-2XGT (370W) EI
• H P 513 0 -48G-PoE+-2SFP+-2XGT (370W) EI
• H P 513 0 -48G-4SFP+ EI BR
• H P 513 0 -24G-PoE+-4SFP+ (370W) EI BR
• H P 513 0 -48G-PoE+-4SFP+ (370W) EI BR

HP 5130 EI Switch Series Specifications

General

Brand	HP
Model	5130 EI Switch Series
Category	Switch
Language	English