HP 5130 EI Switch Series User Manual

49
NOTE:
HP
recommends that you use HP 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, or S
FP+
DAC cable
s for the SFP+ ports on the switch. The HP 1000 Mbps SFP and SFP+ transceiver module
s are
subject to change over time. For the most up
-to-date list of SFP and SFP+ transceiver modules, contact
your
HP sales representative or technical support engineer.
For more information about the 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, and
SFP+ DAC cables, see HP Comware-Based Devices Transceiver Modules User Guide.
Figure 52 SFP+ DAC cable
(1) Connector
(2) Pull latch
Combo interface
The H P 513 0 -24G-SFP-4SFP+ EI switch provides eight combo interfaces. A combo interface includes an
SFP port and a 10/100/1000Base-T autosensing Ethernet port. Only one of these two ports can operate
at a time.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Table 19 System status LED description
LED mark Status Description
SYS
Steady green The switch is operating correctly.
Flashing green The switch is performing power-on self test (POST).
Steady red The switch has failed POST.
Flashing yellow Some ports have failed POST.
Off The switch is powered off.
1
2

HP 5130 EI Switch Series Specifications

General

Brand	HP
Model	5130 EI Switch Series
Category	Switch
Language	English