HP 5130 EI Switch Series User Manual

19
Figure 24 Connecting the DC power cord to an HP 5130-24G-SFP-4SFP+ EI switch
Connecting the switch to an RPS
CAUTION:
To connect the switch to an HP RPS, you can only use the power cord that is provided with the RPS.
To connect the switch to an RPS:
1. Correctly orient the plug with the power receptacle on the power supply, and insert the plug into
the receptacle (See callout 1 in Figure 24).
If you cannot insert the plug into the receptacle, re-orient the plug rather than use excessive force
to push it in.
2. Tighten the screws on the plug with a flat-blade screwdriver to secure the plug in the RPS receptacle.
See callout 2 in Figure 24.
3. Connect the other end of the power cord to the RPS.
Figure 25 Connecting an RPS cord to an HP 5130-48G-4SFP+ EI switch
Verifying the installation
After you complete the installation, verify that:
•
There is enough space for heat dissipation around the switch, and the rack or workbench is stable.
1
2
1
2

HP 5130 EI Switch Series Specifications

General

Brand	HP
Model	5130 EI Switch Series
Category	Switch
Language	English