HP 5130 EI Switch Series User Manual

14
Figure 16 Grounding through the PE wire of the AC power cord
(1) Chassis rear panel
(2) Three-wire AC power cable
NOTE:
To guarantee the grounding effect,
use the grounding cable provided with the switch to connect to the
grounding strip in the equipment room as long as possible.
Installing and removing a power supply (HP
5130-24G-SFP-4SFP+ EI switch)
CAUTION:
Provide a circuit breaker for each power supply and make sure the circuit breaker is off before installation.
The H P 513 0 -24G-SFP-4SFP+ EI switch provides two power supply slots and comes with power supply slot
1 empty and a filler panel in power supply slot 2. You can install one power supply, or two power
supplies for redundancy. For information about power supplies available for the HP
513 0 -24G-SFP-4SFP+ EI switch, see "Appendix B FRUs."
When two power supplies are installed, you can hot-swap a power supply. To avoid device damage and
bodily injury, follow the procedures in Fi g u re 17 and Figure 18 to install and replace a power supply.
Figure 17 Installation procedure
2
1
安装电源模块 连接电源线
给电源模块加电安装电源模块
连接电源线 给电源模块加电安装电源模块
连接电源线
给电源模块加电
Install the power supply
Connect the power cord
Turn on the circuit
breaker

HP 5130 EI Switch Series Specifications

General

Brand	HP
Model	5130 EI Switch Series
Category	Switch
Language	English