3-10
Getting Started With Switch Configuration
Configuring the ProCurve Wireless Edge Services zl Modules (J9051A, J9052A)
Getting Started With Switch
Configuration
Configuring Wireless LAN Services
To configure wireless LAN services on a wireless services-enabled zl switch,
use one of the following management interfaces for the module:
■ Web browser interface — Accessed through a Web browser, this
intuitive interface provides comprehensive information to help you
manage and monitor your company’s wireless services. The menus
and online help guide you through configuration steps. See the
ProCurve Wireless Edge Services zl Modules Management and
Configuration Guide for information on using the Web browser
interface to configure and manage a module.
To run the Web browser interface for the ProCurve Wireless Edge
Services zl Module, your workstation must be running Java Virtual
Machine (JVM). If your workstation is not running the JVM and you
attempt to open the module’s Web browser interface, the workstation will
automatically try to access the Internet and download the JVM.
■ Command line interface (CLI) — Available through a serial, Telnet,
or Secure Shell (SSH) session to the zl switch, the wireless-services
context, accessed from the zl switch’s CLI config context, provides a
complete set of commands to configure, manage, and troubleshoot
your wireless services.
The CLI commands available in the wireless-services context of the zl
switch CLI are documented in an appendix of the ProCurve Wireless Edge
Services zl Modules Management and Configuration Guide. Refer to this
manual for more information.
The Web browser interface simplifies both management and configuration
tasks, and is recommended in most instances.
To Next Page
Loading...
Need help?
General