1. Remove the four screws on the top front of the tower.
X
2. Working on the top frame, at the rear of the system, remove the screws from the bracket
on the right, and the ones on the left.
Y
3. Lift the top frame panel off by pulling the frame out and lifting it up.
Z
4. Complete the removal of the back frame by removing the two screws (below the fans)
holding it to the base.
[
5. Along the bottom of the left panel, remove two screws holding a long thin rectangular
bracket at the base.
\
6. Remove the three screws down the front left side frame.
]
Prepare the System 2-5
To Next Page
Loading...
Need help?
General