Contents
Preface
Chapter 1 Overview
1.1 System Components .............................................................................................. 1-2
1.2 Upgrades Steps ...................................................................................................... 1-3
1.3 Check Upgrades Kits ............................................................................................. 1-4
1.4 Update Firmware ...................................................................................................1-6
1.5 Shut Down System Power ..................................................................................... 1-6
Chapter 2 Prepare the ES47 M2 System
2.1 Remove the Tower System’s Panels...................................................................... 2-2
2.2 Remove the Top, Left, and Rear Frames ............................................................... 2-4
2.3 Remove the Right and Bottom Frames.................................................................. 2-6
2.4 Remove the Fans ...................................................................................................2-8
2.5 Unplug the IDE Cable from the I/O Expander .................................................... 2-10
2.6 Remove the OCP ................................................................................................. 2-12
2.7 Reposition the Disk/CD Unit...............................................................................2-14
2.8 Reposition the OCP ............................................................................................. 2-16
2.9 Reseat the Fans .................................................................................................... 2-17
2.10 Close Module Door.............................................................................................. 2-18
Chapter 3 Install and Cable the Drawers
3.1 Prepare the Cabinet................................................................................................ 3-2
3.2 Install the Brackets ................................................................................................3-4
3.3 Install the 2P Drawer ............................................................................................. 3-6
3.4 Install the IP Cables (M4 only).............................................................................3-7
3.5 Connect SM LAN, Ground, and Power Cables (M4 only) .................................... 3-8
3.6 Install I/O Cable Support ..................................................................................... 3-10
3.7 Install the Bezel (M4 only) .................................................................................. 3-11
3.8 Replace the Side Panel......................................................................................... 3-12
3.9 Set Drawer IDs .................................................................................................... 3-14
3.10 Restore Power...................................................................................................... 3-16
v
To Next Page
Loading...
Need help?
General