To Next Page

To Previous Page

12 Chapter1

Remove/Replace System Components

Removing/Replacing System Components

The procedures in this section describe how to remove/replace the HP B2600 workstation

system components. Note that you need to observe the electrostatic discharge (ESD)

precautions and the prerequisites for installing and removing system components in the

subsequent sections, as well as any NOTEs, CAUTIONs, and WARNINGs in each system

upgrade procedure.

NOTE If you need to install a new system component, simply follow the procedures

for replacing the particular component in this chapter.

Electrostatic Discharge (ESD) Precautions

To prevent damage to the HP B2600 workstation, observe all of the following ESD

precautions while performing the system upgrade procedures:

• Work on a static-free mat.

• Wear a static strap to ensure that any accumulated electrostatic charge is discharged

from your body to ground.

• Create a common ground for the equipment you are working on by connecting the

static-free mat, static strap, and peripheral units to that piece of equipment.

• Keep uninstalled printed circuit boards in their protective antistatic bags.

• Handle printed circuit boards by their edges, once you have removed them from their

protective antistatic bags.

HP b2600 Supplementary Guide

Other manuals for HP b2600