HP Compaq NC4010 Software Guide

2–12 Software Guide
Power
Using the SpeedStep Window
To open the SpeedStep window select Start > Settings > Control
Panel > Power Management icon > Intel SpeedStep technology
tab. Then set your preferences according to the following table.
Enabling SpeedStep in Computer Setup
Computer Setup, a non-Windows utility, includes settings to
enable or disable SpeedStep. For more information about
Computer Setup, refer to Chapter 7, “Computer Setup” in this
guide.
Access the SpeedStep settings in Computer Setup.
1. To open Computer Setup, turn on or restart the notebook.
Press
F10 while the F10 = ROM Based Setup message is
displayed in the lower left of the screen.
❏ To change the language, press F2.
❏
For navigation instructions, press F1.
Preference Procedure
Assign a performance mode that
applies when the notebook is
running on battery power.
Select a performance mode
from the Running on Batteries
list, then select OK.
Assign a performance mode that
applies when the notebook is
running on AC power.
Select a performance mode
from the Plugged In list, then
select OK.
Set the notebook to remain in the
same performance mode even if
the power source changes.
Select the same performance
mode from the Running on
Batteries and Plugged In lists,
then select OK.
Remove the SpeedStep icon from
the taskbar.
1. Select the check box for
Remove Icon from Taskbar.
2. Select OK in the Advanced
window.
3. Select OK or Apply in the
main SpeedStep window.
310029-002.book Page 12 Friday, October 24, 2003 1:48 PM

HP Compaq NC4010 Specifications

General

Brand	HP
Model	Compaq NC4010
Category	Laptop
Language	English