4–4 Software Guide
Optical Drive Software
Installing Software
To install software included with the notebook from a CD, follow
these steps:
1. Insert an appropriate optical drive into an External MultiBay
connected to the notebook as described in the “External
Devices” chapter of the Hardware Guide on the
Documentation Library CD.
2. Connect the notebook to a reliable electrical outlet.
3. Close any open applications.
4. Insert a software CD into the optical drive.
❏ If Autorun is enabled, an Installation Wizard is displayed.
❏ If Autorun is disabled, select Start > Run. Enter:
x:\setup.exe
(where x is your CD drive designation), then select the
OK button.
5. When the Installation Wizard is displayed, follow the
installation instructions on the screen.
6. Restart the notebook if prompted.
✎
Repeat the installation procedure for all software you want to
install.
✎
WinDVD Creator has special drive requirements for proper
installation. To install WinDVD Creator, see the instructions
provided with the InterVideo WinDVD Creator CD.
310029-002.book Page 4 Friday, October 24, 2003 1:48 PM
To Next Page
Loading...
Need help?
General