MultiBoot
Software Guide 5–3
✎
Since no drive letter is associated with the NIC, changing the boot
order of a NIC does not affect drive letters of the other devices.
Enabling Devices in Computer Setup
The notebook can start up from a USB device or the NIC only if
that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. Turn on or restart the notebook. Press
F10 while the
F10 = ROM Based Setup message is displayed in the lower
left of the screen.
❏ To change the language, press F2.
❏
For navigation instructions, press F1.
2. Use the arrow keys to select the Advanced menu > Device
Options.
❏ To enable bootable media in USB drives or in drives
inserted into a Port Replicator, select Enable USB legacy
support.
❏ To enable a NIC, select Internal Network adapter boot.
3. To save your preferences and exit Computer Setup, use the
arrow keys to select File > Save Changes and Exit, then
follow the instructions on the screen.
Your preferences are set as you exit Computer Setup and are
in effect when the notebook restarts.
✎
To connect a NIC to a Preboot eXecution Environment (PXE) or
Remote Program Load (RPL) server during startup without using
MultiBoot, quickly press
F12 when the Network Service Boot
message appears briefly in the lower right corner of the screen.
310029-002.book Page 3 Friday, October 24, 2003 1:48 PM
To Next Page
Loading...
Need help?
General