Adjustments
Display Brightness and Contrast Adjustment
3-12 HP EPM-441A/442A Service Guide
Display Brightness and Contrast Adjustment
Introduction
The following procedure should be performed whenever a front panel
assembly or processor assembly are replaced.
The brightness is controlled automaticaly after executing the
softkey, located under the softkey menu.
Note The contrast adjustment is subjective and varies according to
individual user requirements.
Procedure
1. Access the softkey menu and use the softkey to
increase the contrast, or the softkey to decrease the contrast
of the display.
2. When the desired display contrast level is obtained, press the
softkey, located under the softkey
menu.
Set Brightness
Service
Display
Set Contrast Service
4402serv.book Page 12 Monday, March 11, 2002 11:34 AM
To Next Page
Loading...
Need help?
General
