160
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable prefix suppression
on the interface.
isis prefix-suppression
By default, prefix suppression is
disabled on the interface.
This command is also
applicable to the secondary IP
address of the interface.
Configuring IS-IS network management
This task includes the following configurations:
Bind an IS-IS process to MIB so that you can use network management software to manage the
specified IS-IS process.
Enable IS-IS notifications to report important events.
Notifications are delivered to the SNMP module, which outputs the notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management
and Monitoring Configuration Guide.
To configure IS-IS network management:
1. Enter system view.
N/A
2. Bind MIB to an IS-IS
process.
isis mib-binding
process-id
By default, MIB is bound to the
IS-IS process with the smallest
process ID.
3. Enable IS-IS notification
sending.
snmp-agent trap enable isis
[
adjacency-state-change
|
area-mismatch
|
authentication
|
authentication-type
|
buffsize-mismatch
|
id-length-mismatch
|
lsdboverload-state-change
|
lsp-corrupt
|
lsp-parse-error
|
lsp-size-exceeded
|
manual-address-drop
|
max-seq-exceeded
|
maxarea-mismatch
|
own-lsp-purge
|
protocol-support
|
rejected-adjacency
|
skip-sequence-number
|
version-skew
] *
By default, IS-IS notification
sending is enabled.
4. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
5. Configure the context
name for the SNMP object
for managing IS-IS.
snmp
context-name
context-name
By default, no context name is set
for the SNMP object for
managing IS-IS.
Configuring IS-IS PIC
Prefix Independent Convergence (PIC) enables the device to speed up network convergence by
ignoring the number of prefixes.
To Next Page
Loading...
Need help?
General