HP HPE FlexNetwork 7500 series User Manual

11
Step
Command
Remarks
6. (Optional.) Enable
periodic sending of
ARP requests to the
next hops of static
routes.
ip route-static arp-request interval
interval
By default, the device does
not send ARP requests to
the next hops of static
routes.
7. (Optional.)
Configure the
default preference
for static routes.
ip route-static default-preference
default-preference
The default setting is 60.
8. (Optional.) Delete all
static routes,
including the default
route.
delete
[
vpn-instance
vpn-instance-name ]
static-routes all
To delete one static route,
use the
undo ip
route-static
command.
Configuring BFD for static routes
IMPORTANT:
Enabling BFD for a flapping route could worsen the situation.
BFD provides a general-purpose, standard, medium-, and protocol-independent fast failure
detection mechanism. It can uniformly and quickly detect the failures of the bidirectional forwarding
paths between two routers for protocols, such as routing protocols and MPLS.
For more information about BFD, see High Availability Configuration Guide.
Bidirectional control mode
To use BFD bidirectional control detection between two devices, enable BFD control mode for each
device's static route destined to the peer.
To configure a static route and enable BFD control mode, use one of the following methods:
•
Specify an output interface and a direct next hop.
•
Specify an indirect next hop and a specific BFD packet source address for the static route.
To configure BFD control mode for a static route (direct next hop):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Configure BFD
control mode for a
static route.
• Method 1:
ip route-static dest-address { mask-length |
mask } interface-type interface-number
next-hop-address bfd control-packet
[ preference preference ] [ tag tag-value ]
[ description text ]
• Method 2:
ip route-static vpn-instance
s-vpn-instance-name dest-address
{ mask-length | mask } interface-type
interface-number next-hop-address bfd
control-packet [ preference preference ] [ tag
tag-value ] [ description text ]
By default, BFD control
mode for a static route
is not configured.
To configure BFD control mode for a static route (indirect next hop):

HP HPE FlexNetwork 7500 series Specifications

General

Brand	HP
Model	HPE FlexNetwork 7500 series
Category	Switch
Language	English