386
# Configure the IP address of VLAN-interface 10.
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address 1.1.2.2 24
3. Configure Switch C:
# Create VLAN 20.
<SwitchC> system-view
[SwitchC] vlan 20
[SwitchC-vlan20] quit
# Configure the IP address of VLAN-interface 20.
[SwitchC] interface vlan-interface 20
[SwitchC-Vlan-interface20] ip address 1.1.3.2 24
Verifying the configuration
# Telnet to Switch B on Switch A. The operation succeeds.
# Telnet to Switch C on Switch A. The operation fails.
# Ping Switch C from Switch A. The operation succeeds.
Telnet uses TCP, and ping uses ICMP. The results show the following:
All TCP packets sent from Switch A are forwarded to the next hop 1.1.2.2.
Other packets are forwarded through VLAN-interface 20.
The local PBR configuration is effective.
Packet type-based interface PBR configuration example
Network requirements
As shown in Figure 89, configure PBR on Switch A to forward all TCP packets received on
VLAN-interface 11 to the next hop 1.1.2.2. Switch A forwards other packets according to the routing
table.
To Next Page
Loading...
Need help?
General