Software and configuration utilities 48
Installing an operating system
To install an OS, download the SATA RAID driver and create a driver diskette with the software and
instructions from the HP website (http://www.hp.com/support
).
Installing a supported Microsoft® Windows® OS
1. Insert the OS CD and reboot the system.
2. When prompted, press the F6 key to install a third-party driver.
NOTE: Press F6 within 5 seconds to enable the system to recognize the controller. If the
system fails to recognize the controller, restart this procedure.
3. Insert the SATA RAID driver diskette created earlier. The system prompts the next action.
4. Press the S key to specify the driver from the diskette. Then, press the Enter key. The OS searches the
diskette for a suitable driver.
5. After locating the Adaptec Embedded Serial ATA HostRAID driver, press Enter.
6. Follow the remaining on-screen instructions to complete the installation.
Installing a supported Linux OS
To install a supported Linux OS when using the HP Embedded SATA RAID controller, see the OS
documentation.
To Next Page
Loading...
Need help?
General
